Precision Rail-to-Rail Input & Output Operational Amplifiers

GENERAL DESCRIPTION The OP184/OP184/OP284/OP484 are single, dual and quad single-supply, 4 MHz bandwidth amplifiers featuring rail-to-rail inputs and outputs. They are guaranteed to operate from +3 to +36 (or ±1.5 to ±18) volts and will function with a single supply as low as +1.5 volts. These

文件：291.83 Kbytes 頁數：20 Pages

AD

亞德諾

Precision Rail-to-Rail Input and Output Operational Amplifiers

FEATURES Single-supply operation Wide bandwidth: 4 MHz Low offset voltage: 65 μV Unity-gain stable High slew rate: 4.0 V/μs Low noise: 3.9 nV/√Hz APPLICATIONS Battery-powered instrumentation Power supply control and protection Telecommunications DAC output amplifier ADC input

文件：675.95 Kbytes 頁數：24 Pages

AD

亞德諾

Operational Amplifiers

DESCRIPTION: Maxwell Technologies’ OP284 is a dual single-supply, 4 MHz bandwidth amplifier featuring rail-to-rail inputs and outputs and a greater than 100 krad (Si) total dose tolerance,depending upon space mission. Using Maxwell Technologies’ radiation-hardened RAD-PAK? technology, it is guara

文件：861.29 Kbytes 頁數：16 Pages

MAXWELL

TORQUE PRODUCTS

文件：3.50277 Mbytes 頁數：32 Pages

ETCList of Unclassifed Manufacturers

未分類制造商

Technical Article

文件：248.36 Kbytes 頁數：5 Pages

AD

亞德諾

Precision Rail-to-Rail Input & Output Operational Amplifiers

文件：522.84 Kbytes 頁數：20 Pages

AD

亞德諾

Precision Rail-to-Rail Input and Output Operational Amplifiers

文件：508.22 Kbytes 頁數：24 Pages

AD

亞德諾

精密RRIO雙通道運算放大器

OP184 / OP284 / OP484分別是單通道/雙通道/四通道、單電源、4 MHz帶寬放大器，具有軌到軌輸入與輸出特性。保證工作電壓范圍為+3 V至+36 V（或±1.5 V至±18 V），可以采用低至+1.5 V的單電源工作。\n\n 這些放大器非常適合要求交流性能與精密直流性能的單電源應用。帶寬、低噪聲與精度特性組合，則使之適合濾波器和儀器儀表等各種應用。\n\n 其它應用包括便攜式電信設備、電源控制與保護，以及用作具有寬輸出范圍傳感器的放大器或緩沖器。要求采用軌到軌輸入放大器的傳感器包括霍爾效應傳感器、壓電傳感器和阻性傳感器。\n\n 利用軌到軌輸入 ? 單電源供電 \n\n? 寬帶寬：4 MHz \n\n? 低失調電壓：65 μV \n\n? 單位增益穩定 \n\n? 高壓擺率：4.0 V/μs \n\n? 低噪聲：3.9 nV/√Hz \n\n? 請參閱數據表了解更多信息;

ADI

亞德諾

Dual Operational Amplifier

DESCRIPTION: Maxwell Technologies’ OP284A is a dual single-supply, 4 MHz bandwidth amplifier featuring rail-to-rail inputs and outputs. Using Maxwell Technologies’ radiation-hardened RADPAK? technology, it is guaranteed to operate from +3 to +36 (or ±1.5 to ±18) volts and will function with a s

文件：875.39 Kbytes 頁數：16 Pages

MAXWELL

Dual Operational Amplifier

DESCRIPTION: Maxwell Technologies’ OP284A is a dual single-supply, 4 MHz bandwidth amplifier featuring rail-to-rail inputs and outputs. Using Maxwell Technologies’ radiation-hardened RADPAK? technology, it is guaranteed to operate from +3 to +36 (or ±1.5 to ±18) volts and will function with a s

文件：875.39 Kbytes 頁數：16 Pages

MAXWELL