Ultralow Power, Rail-to-Rail Output Operational Amplifiers

GENERAL DESCRIPTION The OP181, OP281 and OP481 are single, dual and quad ultralow power, single-supply amplifiers featuring rail-to-rail outputs. All operate from supplies as low as 2.0 V and are specified at +3 V and +5 V single supply as well as ±5 V dual supplies. FEATURES Low Supply

文件：448.07 Kbytes 頁數：16 Pages

AD

亞德諾

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

GENERAL DESCRIPTION The AD8546 and AD8548 are dual and quad micropower, high input impedance amplifiers optimized for low power and wide operating supply voltage range applications. The AD8546/AD8548 rail-to-rail input/output (RRIO) feature provides increased dynamic range to drive low frequ

文件：963.34 Kbytes 頁數：16 Pages

AD

亞德諾

22 μA, RRIO, CMOS, 18 V Operational Amplifier

FEATURES Micropower at high voltage (18 V): 22 μA maximum Low input bias current: 20 pA maximum Gain bandwidth product: 240 kHz at AV =100 typical Unity-gain crossover: 240 kHz ?3 dB closed-loop bandwidth: 310 kHz Slew rate: 80 V/ms Large signal voltage gain: 110 dB minimum Single-supply operat

文件：709.49 Kbytes 頁數：24 Pages

AD

亞德諾

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

FEATURES Low supply current: 4 μA/amplifier maximum Single-supply operation: 2.7 V to 12 V Wide input voltage range Rail-to-rail output swing Low offset voltage: 1.5 mV No phase reversal APPLICATIONS Comparator Battery-powered instrumentation Safety monitoring Remote sensors Low voltag

文件：396.26 Kbytes 頁數：20 Pages

AD

亞德諾

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

文件：446.33 Kbytes 頁數：20 Pages

AD

亞德諾

22 關A, RRIO, CMOS, 18 V

文件：696.47 Kbytes 頁數：24 Pages

AD

亞德諾

MicroConverter? 12-Bit ADCs and DACs with Embedded High Speed 62-kB Flash MCU

文件：908.68 Kbytes 頁數：88 Pages

AD

亞德諾

超低功耗、軌到軌輸出運算放大器（雙通道）

OP281和OP481分別是雙通道和四通道、超低功耗、單電源放大器，具有軌到軌輸出特性。各器件均可采用低至2.0 V的電源供電，額定電源電壓為+3 V、+5 V（單電源）和±5 V（雙電源）。\n\n OP281/OP481采用ADI的CBCMOS工藝制造，具有精密雙極性輸入，輸出擺幅達到電源電壓的數毫伏范圍內，并且只要輸出電壓不大于電源電壓，就可以持續提供吸電流或源電流。\n\n 具體應用包括安全監控、便攜式設備、電池和電源控制，以及極低功耗系統中的傳感器信號調理和接口。\n\n OP281/OP481具有軌到軌輸出擺幅，將輸出驅動至電源電壓時無需提高電源電流， ? 低電源電流：每個放大器4 μA（最大值）\n\n? 單電源供電：2.7 V至12 V\n\n? 寬輸入電壓范圍\n\n? 軌到軌輸出擺幅 \n\n? 低失調電壓：1.5 mV\n\n? 無反相;

ADI

亞德諾

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

FEATURES Low supply current: 4 μA/amplifier maximum Single-supply operation: 2.7 V to 12 V Wide input voltage range Rail-to-rail output swing Low offset voltage: 1.5 mV No phase reversal APPLICATIONS Comparator Battery-powered instrumentation Safety monitoring Remote sensors Low voltag

文件：396.26 Kbytes 頁數：20 Pages

AD

亞德諾

Ultralow Power, Rail-to-Rail Output Operational Amplifiers

GENERAL DESCRIPTION The OP181, OP281 and OP481 are single, dual and quad ultralow power, single-supply amplifiers featuring rail-to-rail outputs. All operate from supplies as low as 2.0 V and are specified at +3 V and +5 V single supply as well as ±5 V dual supplies. FEATURES Low Supply

文件：448.07 Kbytes 頁數：16 Pages

AD

亞德諾