30V Li Linear Battery Charger with GSM Test Mode in 3mm x 2mm TDFN

General Description The MAX8922L linear battery charger safely charges a single-cell lithium-ion (Li+) battery. Charging rate is optimized to accommodate the thermal characteristics of a given application. There is no need to reduce the maximum charge current at the worst-case charger power dissi

文件：704.11 Kbytes 頁數：15 Pages

MAXIM

美信

30V Li Linear Battery Charger with GSM Test Mode in 3mm x 2mm TDFN

General Description The MAX8922L linear battery charger safely charges a single-cell lithium-ion (Li+) battery. Charging rate is optimized to accommodate the thermal characteristics of a given application. There is no need to reduce the maximum charge current at the worst-case charger power dissi

文件：704.11 Kbytes 頁數：15 Pages

MAXIM

美信

30V Li+電池線性充電器，提供GSM測試模式，3mm x 2mm TDFN封裝

MAX8922L線性電池充電器可對單節鋰離子(Li+)電池安全充電。充電速率根據特定應用的溫度特性進行了優化，無需在最差的充電器功耗條件下降低最大充電電流。針對單節Li+電池充電優化的充電控制算法包括低電池電壓預充、限壓和限流快充以及浮充，在充電的同時連續監測輸入過壓狀態和器件的管芯溫度?？斐潆娏骱透〕潆娏鏖T限可通過簡單的1-Wire?串行接口設置?？赏ㄟ^2個漏極開路輸出(/CHG和/POK)指示充電器狀態和有效的輸入電源。\n快充電流的默認值為400mA，可通過1-Wire接口(/EN/SET)進行設置。MAX8922L還可通過1-Wire接口設置為GSM測試模式。\nMAX8922L采用纖 ·具有過壓保護的30VDC額定輸入(IN) \n·帶有輸入過壓保護的安全4.94V LDO輸出\n·2.3A GSM RF測試模式 \n·無需外部FET、阻斷二極管或檢測電阻 \n·可通過1-Wire方便地設置快充電流和GSM測試模式(/EN/SET)\n·可通過電阻設置快充電流(SETI)\n·可通過電阻設置浮充電流門限(MIN) \n·預充電 \n·電源就緒監測輸出(/POK)\n·充電狀態指示輸出(/CHG) \n·調節管芯溫度以優化充電速率\n·纖小的(3mm x 2mm x 0.8mm)、10引腳TDFN封裝;

ADI

亞德諾

Package：10-WFDFN 裸露焊盤；包裝：卷帶（TR） 類別：集成電路（IC） 電池充電器 描述：IC BATT CHG LI-ION 1CELL 10TDFN

AD

亞德諾