Dual Pushbutton Controllers in Tiny 6-Bump WLP Package

General Description The MAX16122–MAX16125 pushbutton controllers with single-supply monitors monitor one or two pushbuttons and generate a hard reset signal if the buttons are pushed and held for a setup delay. These devices make it easy to “hide” the hard reset function in an existing pushbutton

文件：845.32 Kbytes 頁數：16 Pages

MAXIM

美信

雙按鍵控制器，采用微型6焊球WLP封裝

MAX16122–MAX16125按鍵控制器內部集成了單電源監測器，用于監測一個或兩個按鍵，如果按鍵按下并且保持時間達到了建立延遲時間，則產生硬件復位信號。利用這些器件很容易將硬件復位功能“隱藏”在按鍵下方，例如軟電源開關。器件工作在1.6V至5.5V，3V時消耗靜態電流僅為5μA。MAX16122–MAX16125提供引腳可編程或電阻可調節建立延時。將SEL引腳連接至GND、VCC或保持浮空，以選擇不同的建立延時(取決于器件型號后綴，見表1a)；或者在SEL和GND之間連接一個外部電阻，設置建立延時(僅限后綴為E的型號，見表1b)。MAX16124/MAX16125具有一路手動復位輸入(/M ? 低電源電流：<5μ (典型值) (3V供電，全溫度范圍)\n? 固定/引腳可編程或電阻可調節按鍵建立延時\n? VCC低至0.95V時，確保/ RESET可靠輸出 \n? 不受電源瞬變的影響\n? -40°C至+125°C工作溫度范圍;

ADI

亞德諾

Dual Pushbutton Controllers in Tiny 6-Bump WLP Package

General Description The MAX16122–MAX16125 pushbutton controllers with single-supply monitors monitor one or two pushbuttons and generate a hard reset signal if the buttons are pushed and held for a setup delay. These devices make it easy to “hide” the hard reset function in an existing pushbutton

文件：845.32 Kbytes 頁數：16 Pages

MAXIM

美信

16 (26/30) AWG Bare Copper

文件：412.79 Kbytes 頁數：4 Pages

ALPHAWIRE

16 (26/30) AWG Bare Copper

文件：413.38 Kbytes 頁數：5 Pages

ALPHAWIRE

16 (26/30) AWG Bare Copper

文件：412.7 Kbytes 頁數：4 Pages

ALPHAWIRE