Single-Bus RS485/RS232 Multiprotocol Transceiver with Switchable Termination

DESCRIPTION The LTC?2873 is a robust pin-configurable multiprotocol transceiver that supports RS232, RS485, and RS422 protocols while operating on a single 3V to 5.5V supply. The LTC2873 can be configured as a half-duplex RS485 transceiver or as an RS232 transceiver using the same two bus pins.

文件：1.62623 Mbytes 頁數：32 Pages

AD

亞德諾

?60V Fault Protected 3V to 5.5V RS485/RS422 Transceiver with Level 4 IEC ESD

DESCRIPTION TheLTC?2862Ais a low power,20Mbpsor250kbpsRS485/RS422 transceiver operating on 3V to 5.5V supplies with ±60V overvoltage fault protection on the interface pins during all modes of operation, including power-down. Improvements were made to the LTC2862 for greater robustness and signal

文件：478.68 Kbytes 頁數：22 Pages

AD

亞德諾

±60V Fault Protected 3V to 5.5V RS485/RS422 Transceiver with Level 4 IEC ESD

FEATURES - Protected from Overvoltage Line Faults to ±60V 3V to 5.5V Supply Voltage - 20Mbps or Low EMI 250kbps Data Rate - ±40kV HBM ESD Interface Pins, ±15kV Other Pins - Enhanced Receiver and Failsafe Noise Immunity - IEC Level 4 ESD and EFT on Interface Pins - Extended Common Mode Rang

文件：999.96 Kbytes 頁數：24 Pages

AD

亞德諾

3.3V 20Mbps RS485/RS422 Transceivers with Integrated Switchable Termination

文件：234.58 Kbytes 頁數：16 Pages

LINER

凌力爾特

20Mbps RS485 Transceivers

文件：340.25 Kbytes 頁數：18 Pages

LINER

凌力爾特

3.3V 20Mbps RS485/RS422 Transceivers with Integrated Switchable Termination

文件：227.48 Kbytes 頁數：16 Pages

LINER

凌力爾特

?60V Rugged PROFIBUS RS485 Transceivers

文件：1.65321 Mbytes 頁數：32 Pages

LINER

凌力爾特

?60V Fault Protected 3V to 5.5V RS485/RS422 Transceiver with Level 4 IEC ESD

文件：478.68 Kbytes 頁數：22 Pages

LINER

凌力爾特

具集成可通斷終端的 3.3V 20Mbps RS485/RS422 收發器

LTC?2854 和 LTC2855 是低功率、20Mbps RS485/RS422 收發器，采用 3.3V 工作電源。接收器包括一個邏輯可選的 120Ω 終端，可在每根總線上支持多達 256 個節點的 1/8 單位負載 (C、I 等級) 和一種可在輸入浮置或短路的條件下確保高輸出狀態的故障保險功能。 當被停用或電源被拿掉時，驅動器能夠在整個共模范圍內保持高輸出阻抗。可通過對所有輸出進行限流和利用熱停機功能來防止因總線爭用或故障而導致功耗過大。 增強型 ESD 防護使得 LTC2854 和 LTC2855 分別能夠在收發器接口引腳上承受 ±25kV 和 ±15kV HBM (人體模型)，而不會 ? 集成邏輯可選的 120Ω 終端電阻器 \n? 3.3V 電源電壓 \n? 20Mbps 最大數據速率 \n? 在高達 ±25kV HBM 的條件下未發生損壞或鎖斷現象 \n? 高輸入阻抗支持 256 個節點 (C、I 等級) \n? 工作溫度高達 125oC (H 等級)\n? 整個共模范圍內的保證故障保險接收器操作\n? 電流受限驅動器和熱停機\n? 延遲微功率停機：最大電流消耗為 5μA (C、I 等級)\n? 上電/斷電無干擾驅動器輸出\n? 低工作電流：接收模式中的典型值為 370μA\n? 符合 TIA/EIA-485-A 規范\n? 采用 10 引腳 3mm x 3mm DFN;

ADI

亞德諾

3.3V 20Mbps RS485/RS422 Transceivers with Integrated Switchable Termination

文件：227.48 Kbytes 頁數：16 Pages

LINER

凌力爾特