LFx98x Monolithic Sample-and-Hold Circuits

1 Features 1? Operates from ±5-V to ±18-V Supplies ? Less than 10-μs Acquisition Time ? Logic Input Compatible With TTL, PMOS, CMOS ? 0.5-mV Typical Hold Step at Ch = 0.01 μF ? Low Input Offset ? 0.002% Gain Accuracy ? Low Output Noise in Hold Mode ? Input Characteristics Do Not Change

文件：3.23114 Mbytes 頁數：41 Pages

TI

德州儀器

Sample-and-hold amplifiers

DESCRIPTION The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize high-voltage ion-implant JFET technology to obtain ultra-high DC accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, DC gain accuracy is 0.002 typical and acquisiti

文件：129.16 Kbytes 頁數：5 Pages

PHI

PHI

MONOLITHIC SAMPLE AND HOLD CIRCUITS

GENERAL DESCRIPTION The LF198/LF298/LF398 are BI-FET monolithic sample and hold circuits with ultra-high DC accuracy, fast acquisition time (6μ to 0.01) and low droop rate. A bipolar input stage is used to obtain the lowest possible offset voltage and wide bandwidth.

文件：257.2 Kbytes 頁數：7 Pages

ETCList of Unclassifed Manufacturers

未分類制造商

Monolithic Sample-and-Hold Circuits

文件：520.789 Kbytes 頁數：13 Pages

NSC

國半

Monolithic Sample-and-Hold Circuits

文件：2.94745 Mbytes 頁數：33 Pages

TI

德州儀器

LF198/LF298/LF398, LF198A/LF398A Monolithic Sample-and-Hold Circuits

文件：564.8 Kbytes 頁數：15 Pages

TI

德州儀器

LFx98x Monolithic Sample-and-Hold Circuits

文件：3.53831 Mbytes 頁數：38 Pages

TI

德州儀器

單片采樣保持電路（10μs 采集，3mV 失調電壓）

LFx98x 器件是采用 BI-FET 技術的單片采樣保持電路，利用快速采集信號和低下降率獲得超高的直流精度。作為單位增益跟隨器，直流增益精度為 0.002％（典型值），采集時間低至 6μs (0.01％)。采用雙極輸入級以實現低偏移電壓和寬帶寬。輸入偏移調整是通過單個引腳完成的，不會降低輸入偏移漂移。寬帶寬允許將 LFx98x 包含在 1MHz 運算放大器的反饋環路內，而不會出現穩定性問題。輸入阻抗為 1010Ω，允許使用高源阻抗，而不會降低精度。\n\nP 通道結型 FET 與輸出放大器中的雙極器件相結合，通過 1μF 保持電容器提供低至 5mV/min 的下降率。JFET 的噪聲顯著低于 ? 通過 ±5V 至 ±18V 的電源工作\n? 采集時間少于 10μs\n? 邏輯輸入與 TTL、PMOS、CMOS 兼容\n? 在 Ch = 0.01μF 時保持步進為 0.5mV（典型值）\n? 低輸入偏移\n? 增益精度為 0.002%\n? 在保持模式下，輸出噪聲較低\n? 在保持模式期間，輸入特點不變\n? 在采樣或保持模式中，電源抑制比高\(yùn)n? 寬帶寬\n? 符合太空要求，符合 JM38510;

TI

德州儀器

Sample-and-hold amplifiers

DESCRIPTION The LF198/LF298/LF398 are monolithic sample-and-hold circuits which utilize high-voltage ion-implant JFET technology to obtain ultra-high DC accuracy with fast acquisition of signal and low droop rate. Operating as a unity gain follower, DC gain accuracy is 0.002 typical and acquisiti

文件：129.16 Kbytes 頁數：5 Pages

PHI

PHI

絲?。?a target="_blank" title="Marking" href="/lf298m/marking.html">LF298M；Package：SOIC(D)；LFx98x Monolithic Sample-and-Hold Circuits

1 Features 1? Operates from ±5-V to ±18-V Supplies ? Less than 10-μs Acquisition Time ? Logic Input Compatible With TTL, PMOS, CMOS ? 0.5-mV Typical Hold Step at Ch = 0.01 μF ? Low Input Offset ? 0.002% Gain Accuracy ? Low Output Noise in Hold Mode ? Input Characteristics Do Not Change

文件：3.23114 Mbytes 頁數：41 Pages

TI

德州儀器