DRV8210 11-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

1 Features ? N-channel H-bridge motor driver – MOSFET on-resistance: HS + LS 1 Ω – Drives one bidirectional brushed DC motor – Two unidirectional brushed DC motors – One single- or dual-coil latching relay – Push-pull and bistable solenoids – Other resistive, inductive, or LED loads ? 1.65

文件：4.24385 Mbytes 頁數：51 Pages

TI

德州儀器

DRV8212P 11-V H-Bridge Motor Driver with PWM Interface and Low-Power Sleep Mode

1 Features ? N-channel H-bridge motor driver – MOSFET on-resistance: HS + LS 280 mΩ – Drives one bidirectional brushed DC motor – One single- or dual-coil latching relay ? 1.65-V to 11-V operating supply voltage range ? High output current capability: 4-A peak ? Standard PWM Interface (IN1/

文件：2.82934 Mbytes 頁數：34 Pages

TI

德州儀器

DRV8212 11-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

文件：3.04247 Mbytes 頁數：35 Pages

TI

德州儀器

DRV8212 11-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

文件：3.81547 Mbytes 頁數：48 Pages

TI

德州儀器

DRV8212P 11-V H-Bridge Motor Driver with PWM Interface and Low-Power Sleep Mode

文件：2.83535 Mbytes 頁數：34 Pages

TI

德州儀器

DRV8212 11-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

文件：3.81626 Mbytes 頁數：48 Pages

TI

德州儀器

DRV8210 11-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

文件：4.75392 Mbytes 頁數：51 Pages

TI

德州儀器

DRV8212 11-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

文件：4.28246 Mbytes 頁數：49 Pages

TI

德州儀器

DRV8220 18-V H-Bridge Motor Driver with PWM, PH/EN, and Half-Bridge Control Interfaces and Low-Power Sleep Mode

文件：4.38024 Mbytes 頁數：47 Pages

TI

德州儀器

12V、2A 低壓 H 橋電機驅動器

The DRV8212 is an integrated motor driver with four N-channel power FETs, charge pump regulator, and protection circuitry. The tripler charge pump architecture allows the device to operate down to 1.65 V to accommodate 1.8-V supply rails and low-battery conditions. The charge pump integrates all cap ? N-channel H-bridge motor driver \n? Drives one bidirectional brushed DC motor\n? One single- or dual-coil latching relay\n? Other resistive, inductive, or LED loads\n? 1.65-V to 11-V operating supply voltage range\n? Full-bridge: 4-A peak\n? Parallel half-bridge: 8-A peak\n? Multiple interfaces fo;

TI

德州儀器